The Pop! Mould plate is an original and unique product developed for the use of removing Moulds from acrylic as well as assisting to remove moulds from silicone.
This kit does not include any moulds, they are for reference only.
Product has been tested and trialled and will not lose its "stick"
Wash in luke warm water with detergent. Do not use scourer pads to clean.
We recommend using Queen fine food ready to roll fondant, however Satin Ice has also been tested. Please refer to tutorials prior to use.
2. Use a scraper to scrape away excess fondant, leaving only the design filled with fondant
3. Place mat onto the Pop Mould/silicone mould design face up. Press firmly down with your thumbs on the center of the design wiggle with some pressure applied, press back and fourth to create friction.
4. Peel Pop! Mould Plate off the mould/acrylic from one end to the other (don't pull it off, peel it) and your fondant design should be stuck to the Pop Mould mat.
REMOVING MOULDS FROM THE PLATE
1. Apply flour to your lifter tool.
2. Using the corner of your floured lifter, gently go under the design with a 'sawing' action and lift the design off the silicone.
For best results, allow the mould to dry on the mat prior to removal. Removal time can be anywhere from 5 mins-overnight. 5 minutes you will need to carefully remove with lifter, but if left for hours to overnight they will pop off the mat very easily.
